Abstract
A near-field probe fabricated on a printed circuit board (PCB) with a high sensitivity to electric fields is proposed. To achieve high sensitivity, board-level edge plating technology is employed to realize a copper patch replacing conventional pin-type electrodes. In addition, the sensitivity is further enhanced at a specific frequency band based on LC resonance. The proposed electric probe has been experimentally validated by near-field measurements on an application processor (AP) used in latest mobile phones with a sensitivity enhancement of around 20 dB in the Global Positional System (GPS) band compared to a commercial electric probe.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
