A high-resolution tunneling magneto-resistance sensor interface circuit

Abstract

In this paper, a chopper instrumentation amplifier and a high-precision and low-noise CMOS band gap reference in a standard 0.5 [Formula: see text] CMOS technology for a tunneling magneto-resistance (TMR) sensor is presented. The noise characteristic of TMR sensor is an important factor in determining the performance of the sensor. In order to obtain a larger signal to noise ratio (SNR), the analog front-end chip ASIC weak signal readout circuit of the sensor includes the chopper instrumentation amplifier; the high-precision and low-noise CMOS band gap reference. In order to achieve the low noise, the chopping technique is applied in the first stage amplifier. The low-frequency flicker noise is modulated to high-frequency by chopping switch, so that the modulator has a better noise suppression performance at the low frequency. The test results of interface circuit are shown as below: At a single 5 V supply, the power dissipation is 40 mW; the equivalent offset voltage is less than 10 uV; the equivalent input noise spectral density 30 nV/Hz[Formula: see text](@10 Hz), the equivalent input noise density of magnetic is 0.03 nTHz[Formula: see text](@10 Hz); the scale factor temperature coefficient is less than 10 ppm/[Formula: see text]C, the equivalent input offset temperature coefficient is less than 70 nV/[Formula: see text]C; the gain error is less than 0.05%, the common mode rejection ratio is greater than 120 dB, the power supply rejection ratio is greater than 115 dB; the nonlinear is 0.1% FS.