Abstract
In this work, the design and analysis of new Li-Ion battery charger interface using the switching-based technique is proposed for high efficiency, high speed charge and low area. The high efficiency, the lower size area and the fast charge are the more important norms of the proposed Li-Ion battery charger interface. The battery charging is completed passes to each charging mode: The first mode is the trickle charge mode (TC), the second mode is the constant current mode (CC) and the last mode is the constant voltage mode (CV), in thirty three minutes. The new Li-Ion battery charger interface is designed, simulated and layouted in Cadence software using TSCM 180 nm CMOS technology. With an input voltage V<sub>IN</sub> = 4.5 V, the output battery voltage (V<sub>BAT</sub>) may range from 2.7 V to 4.2 V and the maximum charging battery current (I<sub>BAT</sub>) is 1.7 A. The peak efficiency reaches 97% and the total area is only 0.03mm<sup>2</sup> .
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Power Electronics and Drive Systems (IJPEDS)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.