Abstract
Our work’s objective is to improve the performance of advanced battery materials through the use of structurally engineered electrodes that are designed to exploit simultaneously the benefits of both the nano- and micro- length scales. Consequently, a three- dimensional fabrication approach has been developed to enable hierarchical control over electrode structures and surface areas. Potential advantages include improved pathways for electron and ion transport, enhanced mechanical stability, and additional control over interfacial areas and compositions for improved stability and performance. Silicon is an advanced material with promise for use in next generation batteries. Among anode materials, silicon stands out because of its potential for extremely high capacities – more than ten times the specific capacity of the commercial graphite anodes. Two issues that negatively impact the usable capacity and performance of Si anodes are i) large volume changes during charging/discharging and ii) the formation of an unstable solid-electrolyte interphase (SEI). The use of nanostructured electrodes has been effective in accommodating the large volume changes that occur during cycling [1, 2]. However, nanostructuring leads to a very high surface area, which exacerbates problems associated with SEI formation and stability. This study seeks to improve the performance of Si anodes through the use of hierarchically structured electrodes to provide the nanoscale framework needed to accommodate large volume changes while controlling the interfacial area – which affects SEI formation. To accomplish this, electrodes will be fabricated from vertically aligned carbon nanotubes (VACNT) infiltrated with silicon. On the nanoscale, these electrodes allow us to adjust the surface area, porosity, and silicon layer thickness. On the microscale, we have the ability to control the electrode thickness and the incorporation of micro-sized features. For instance, microscopic patterning of the CNT matrix to form vertical holes, as shown in Figure 1, has the potential to impact transport through the electrode – as well as its interfacial area and mechanical stability. Treatment of the surface between the nano- and micro-structured areas can be used to control the size and chemistry of the interface between the electrolyte and the electrode matrix. VACNT-Si composite electrodes were prepared by first synthesizing VACNTs on Si wafers using photolithography for catalyst patterning, followed by aligned CNT growth. Nano-layers of silicon were then deposited on the aligned carbon nanotubes via LPCVD at 200mTorr and 570°C. Figure 2 shows a cross-sectional SEM image of a synthesized VACNT-Si array. A thin copper film was used as the current collector. Electrochemical testing was performed on the electrodes assembled in a CR2025 coin cell with a metallic Li foil as the counter electrode. The impact of the electrode structure on the capacity at various C-rates was investigated. Experiment results demonstrate the influence of structurally engineered electrodes on the performance of silicon electrodes for next generation batteries. References C. K. Chan, H. Peng, G. Liu, K. McIlwrath, X. F. Zhang, R. A. Huggins, and Y. Cui, Nat Nanotechnol,3 (2008), 31-35.K. Evanoff, J. Khan, A. A. Balandin, A. Magasinski, W. J. Ready, T. F. Fuller, and G. Yushin, Adv Mater, 24 (2012), 533-540.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.