Abstract
Abstract This article presents and evaluates a calibration method that significantly improves the spectral information that can be extracted from photon emission signals obtained from semiconductor devices. Step-by-step instructions are given for calibrating photon emission microscopes for specific measurements such as device parameters and material band gap. The article also discusses the types of errors that can occur during calibration. Although the procedure presented is used on InGaAs sensors, it applies to all common photon emission detectors.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
