Abstract
An experimental investigation has been carried out on the influence of grooved casing treatment on the stall margin of a compressor rotor. Tests were conducted with two rotor builds having different solidities (but all other parameters identical) so that one of the rotors exhibited a wall, or casing, type of stall, while the other showed a blade stall. It was found that the casing treatment, when compared to the solid casing, was very effective in increasing the stall margin of the wall stall configuration, whereas there was little or no change in the stall point of the blade stall configuration. Detailed relative frame measurements of the rotor exit flow field were also taken as part of the program. These showed that in a wall stall situation, the use of casing treatment produced a substantial decrease in the relative total pressure defect, compared with the solid casing, while this was not true for the blade stall type of blading. The results of the experiments, both in overall measurements and in the detailed relative frame traverses, support the hypothesis that casing treatment is effective only in a situation in which a wall stall exists.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
