Abstract
To increase the system spatial resolution, this paper presents an eight-channel analog front-end (AFE) with wide bandwidth, low noise for frequency modulation continuous wave (FMCW) LiDAR application. The eight channels are independent of each other. For each channel, the fully differential shunt feedback transimpedance amplifier is adopted to improve the signal noise ratio, and the adaptive dc current cancellation (ADCC) is proposed to prevent the saturation with dc current. The cascaded differential amplifier is employed to achieve gain boosting, bandwidth compensation, and better driving capability. The proposed AFE is fabricated in 0.18 μm CMOS technology. Experimental results indicate the largest transimpedance gain, bandwidth, input referred noise current and dc cancellation are 100 dB, 190 MHz, 37.7 nArms and 280 μA, respectively. The power consumption of each channel is 70 mW with a 3.3 V power supply. The total area of the proposed AFE is approximately equal to 1.2 mm × 2.4 mm, including IO pads.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
