Abstract
The failure rate, the sources of failures and the test costs for nanometer devices are all increasing. Therefore, to create a reliable system-on-a-chip device requires designers to implement fault tolerance. However, while system-level fault tolerance could significantly relax the quality requirements of the system's building blocks, every fault-tolerant scheme only works under certain failure mechanisms and within a certain range of error probabilities. Also, designing a system with a high failure-rate component could be very expensive because the growth rate of the design complexity and the system overhead for fault tolerance could be significantly greater than the component failure rate. Therefore, it is desirable to understand the trade-offs between component test quality and system fault-tolerant capability for achieving the desired reliability under cost constraints. In this paper, the authors propose an analysis framework for system reliability considering (a) the test quality achieved by manufacturing testing, on-line self-checking, and off-line built-in self-test; (b) the fault-tolerant and spare schemes; and (c) the component defect and error probabilities. The authors demonstrate that, through proper redundancy configurations and low-cost testing to insure a certain degree of component test quality, a low-redundant system might achieve equal or higher reliability than a high-redundant system
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have