A finite element analysis on different bone cement forms and injection volumes injected into lumbar vertebral body in percutaneous kyphoplasty

Abstract

BackgroundTo investigate the stress changes between different bone cement forms and injection volumes in adjacent vertebrae after percutaneous kyphoplasty (PKP) by establishing a three-dimensional finite element model of osteoporosis.MethodsA male healthy volunteer was selected. CT of scans L1 to L3 vertebrae were imported into Mimics 21.0 software.The vertebral model of osteoporosiswas established based on previous literature reference. The models were divided into three groups: unilateral, bilateral integration and bilateral separation groups, with each group injecting 2 ml, 4,ml and 6 ml of bone cement, respectively. In all models, a vertical compressive load of 500 N, anterior flexion/posterior extension, left/right bending, and left/right rotation were applied with a moment of 7.5 N/m, of which 85% was applied to the anterior mid-column and 15% to the posterior column. The stress changes between adjacent vertebrae under different conditions were calculated.ResultsAfter percutaneous kyphoplasty was applied to the L2 vertebral body, some differences can be found between the effects of different cement injection volumes and cement morphology on adjacent structures. There was no major difference between the groups when the bone cement injection volume was 2 ml. When the amount of bone cement injected was 4 ml, the bone cement morphology of the bilateral integration group (BIG) produced less stress between adjacent vertebral bodies. The minimum stress was 14.95 MPa in the L3 vertebral body in posterior extension. Whereas the stress levels on adjacent intervertebral structures, BIG shaped bone cement shows some superiority. In addition, the adjacent vertebrae and intervertebral structures are subjected to less stress during left and right rotation.ConclusionsThe present finite element study suggested that bilateral integration bone cement is a suitable form of cement injection, and when the injection volume is 4 ml, reduces stress on adjacent segments by approximately 15% while maintaining the stability of the injected vertebral body.