A FINITE ELEMENT ANALYSIS OF BURR FORMATION IN FACE MILLING OF A CAST ALUMINUM ALLOY

Abstract

The research discussed in this article focuses on the effects of tool geometry (i.e., rake angle and cutting edge radius) and flank wear upon burr formation in face milling of a cast aluminum alloy. As to tool edge preparation, the use of a tool with variable cutting edge radius was investigated using FEM, and compared for its cutting performance (i.e., burr reduction and tool life) with a conventional tool with uniform cutting edge radius. In order to evaluate 3D face milling through 2D orthogonal cutting simulations, the cross-sections that consist in the cutting speed direction and chip flow direction were selected at different locations along the tool rounded corner. At these cross-sections, the local value of cutting edge radius and their associated tool rake angles as well as the effective uncut chip thickness were determined for 2D cutting simulations. In addition, 3D face milling simulations were conducted to investigate more realistic chip flow and burr generation. Comparisons were made for burrs produced from 3D simulations with a sharp tool, 3D simulations with a worn tool and face milling experiments. Finally, recommendations for cutting tool design are made to reduce burr formation in face milling.