Abstract

A uniaxial tension sheet metal coupon with a tapered instead of a straight gage section has been used for centering the location of diffuse neck and for measuring sheet stretchability in a non-uniform strain field. A finite element analysis of such a tensile coupon made of automotive steel sheet metals has been carried out to assess the effect of the tapered gage section geometry and material plastic strain hardening characteristics on the development of local plastic deformation pattern and local stress state, especially beyond the onset of diffuse necking but before localized necking. In particular, the finite element analysis was used in this study to evaluate the accuracy and reliability of an experimental data analysis method for estimating the post-necking effective plastic stress-strain curve based on the direct local surface axial plastic strain measurements for base metal, heat-affected zone, and weld metals of a dual-phase steel DP600. It is concluded that the estimated lower and upper bounds of the effective stress-strain curve at large strains are not satisfactory for low strain-hardening materials such as heat-affected zone and weld metals with the tapered tension coupons. A simple correction method utilizing only the additional local surface strain measurement in the transverse direction is proposed and it is shown to be effective in correcting the estimated effective stress-strain curve of dual-phase steel weld metals obtained for two tapered gage section geometries.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call