Abstract
ABSTRACTA multilayer technology is applied to design a dual‐band branch‐line coupler for the dual‐band balanced amplifier. The proposed coupler is designed based on a three‐layer printed circuit board. The dual‐band operation is achieved by four additional shunt stubs at the middle layer, while the upper layer is the core and active circuits layer and the bottom is ground layer. The proposed coupler with equal power division is designed at two frequencies of 1.1 and 1.9 GHz. Besides, a balanced amplifier is also designed which achieves gain of 11.6 and 10.1 dB at 1.1 and 1.9 GHz, respectively. © 2014 Wiley Periodicals, Inc. Microwave Opt Technol Lett 56:1680–1683, 2014
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.