A do-it-yourself approach for developing a magnetic field mapping setup using a 3D printer

Abstract

The mapping of magnetic fields is an important task for characterizing permanent magnets, their systems, and the various devices that use magnets. However, commercial devices for this task are quite expensive and difficult to acquire. In this study, a design process for an automatized magnetic mapping setup utilizing a 3D printer was proposed via a do-it-yourself approach using common parts found in a laboratory. We used a 3D printer for two purposes: to create instrument parts to fix the Hall probe instead of the printer extruder, and to use the same 3D printer as the position controller of the magnetic probe. We describe the device assembly process, including hardware and software aspects. Several tests of the assembled setup were performed on samples with different magnetic texture dimensions from several centimeters (graduated permanent magnet) to tens of micrometers (flexible magnet with a planar Halbach structure and a 5¼ inch floppy disk). The spatial resolution was in the sub-millimeter range. The parameters of the mapping, such as the number of points and data acquisition time, were optimized for such samples.