Abstract
SUMMARYIn this paper, the results of an oedometric numerical test campaign, performed by means of a 3D Discrete Element Code on idealised cemented granular cylindrical specimens, are illustrated. The idealised microstructure taken into account is characterised by the following: (i) rigid grains bonded to one another; (ii) a high void ratio; and (iii) two different families of voids: the micro and the macro‐voids.The compaction process developing within the specimens, as well as the localization along tabular zones of pure compressive deformation (compaction banding) that in some cases takes place, are discussed. The influence on the evolution of this peculiar strain localization process of many microstructural/numerical parameters like material porosity, macro‐void size, the constitutive relationship adopted for the bonds and the bond damage rate is analysed.Tests for different values of porosity were run. Below a certain porosity threshold value, the onset of mixed modes of localisation was detected whereas the increase in the macro‐void size is observed to favour the onset of instability. Copyright © 2014 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal for Numerical and Analytical Methods in Geomechanics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.