Abstract
This paper describes the Discrete Wavelet transform (DWT) applied for classification and detection of fault with respect to the position of the Static Synchronous Compensator (STATCOM). STATCOM is positioned at mid-point of the transmission line. The reactive power injection or absorption (i.e shifting phase voltage with respect to bus voltage) depends upon the apparent impedance during the fault. The current signals of each phase are retrieved from both sending and receiving end of three phase transmission line synchronously. It starts processing through DWT to acquire spectral energy (SE) content of each phase current signals from both end of the transmission line. Differential spectral energy (DSE) of each phase current signals (i.e SE of current signal recovered from sending end minus SE of current signal recovered at receiving end) of transmission lines is used to record the fault configuration.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Engineering & Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.