A direct comparison amongst different technologies (aerobic granular sludge, SBR and MBR) for the treatment of wastewater contaminated by 4-chlorophenol

Abstract

Environmental concern on chlorinated phenols is rising due to their extreme toxicity even at low concentrations and their persistency in water and soils. Since the high amount of published data often lacks in terms of uniformity, direct comparisons amongst different treatment technologies are very difficult, or even impossible. In this study, granular sludge developed in an acetate-fed Granular sludge Sequencing Batch Reactor (GSBR) was used for the aerobic degradation of low chlorinated 4-chlorophenol (4CP), with readily biodegradable sodium acetate (NaAc) as growth substrate. A conventional Sequencing Batch Reactor (SBR) and a Membrane BioReactor (MBR) were operated in parallel under the same 4CP influent concentrations and/or 4CP volumetric organic loading rates as the GSBR, in order to carry out a direct comparison in terms of 4CP removal efficiencies and specific removal rates, effluent quality, waste sludge production, system simplicity, land area requirement, start-up times, NaAc dosage as growth substrate and maximum applied 4CP volumetric organic loading rate. A decision matrix was built to define the best technology to suit different scenarios: the GSBR was proved to be the most suitable technology when system simplicity, low land area requirement and short start-up times were considered as critical parameters for decision making.