Abstract
A boost power factor correction (PFC) in continuous conduction mode (CCM) by the digital peak current-mode control method with bifurcation control is discussed in this paper. The proposed method is used to prevent the inductor current bifurcation behavior, which is caused by sub-harmonic oscillation when the duty cycle is upon to 50 percent. The bifurcation behavior will increase the inductor current ripple and dissipation, then reduce the Power Factor (PF). Different from the ramp compensation signal performed with analog IC in some papers, a MCU is used to be the controller and also provides the digital compensation function in this paper. With the timer, ADC, PWM, and comparator which are built in the MCU, the necessary parameters will be measured without extra components and additional cost. The proposed method is based on those parameters. In this paper, the MATLAB/Simulink simulation results show the proposed method workable.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
