Abstract
PurposeThis technical procedure describes a method for tracking mandibular movement using a three-dimensional (3D) optical scanner and target tracking system to digitally portray the motion of the mandible and temporomandibular joints by merging cone beam computed tomography (CBCT) data. MethodsFour nonreflective targets were attached to the labial surface of the incisors in a noncolinear arrangement. Mandibular movement was tracked directly using a 3D facial scanner and target tracking software after merging facial scanning data, digital data obtained from a diagnostic cast, and CBCT scan data based on several landmarks of the anterior teeth. The moving path of the subjects’ mandible was converted to CBCT-based data to confirm the actual movement of the mandible and temporomandibular joints. ConclusionsThe digital implementation of mandibular movement using a 3D optical scanner and target tracking system is not prone to the same restrictions and limitations inherent in mechanical equipment; therefore, it is possible to reconstruct more realistic movement(s). This technique can be used in a wide variety of dental applications involving movement of the mandibular jaw, such as fabrication of dental prostheses, or for the diagnosis and treatment of temporomandibular joint disease.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
