A DIC-assisted fringe projection profilometry for high-speed 3D shape, displacement and deformation measurement of textured surfaces

Abstract

High-speed three-dimensional (3D) shape measurement techniques based on fringe projection profilometry (FPP) have undergone huge advances over the past two decades. However, accurate 3D displacement mapping and deformation analysis of dynamic scenes using FPP remains an unsolved problem. Because fringe patterns are projected rather than attached on the tested surfaces, the full-field point-to-point correspondence cannot be accurately established between any two 3D shape results. To deal with this challenge, a DIC-assisted FPP for high-speed 3D shape, displacement and deformation measurement of textured surfaces is proposed. Firstly, a high-speed 3D shape measurement system is adopted using our recently proposed robust and efficient Gray-coded coding strategy, which can accurately reconstruct full-field shape of discontinuous surfaces with rich texture information. Then, the modulation-based method is proposed to retrieve high-quality texture map from three phase-shifting fringe patterns, which can eliminate the adverse influence of the nonuniform and time-varying ambient light. By matching the retrieved surface texture images at difference states using DIC, accurate point tracking between the measured 3D shape data can be fulfilled, leading to precise 3D displacement and deformation measurement. Experiments have verified that the proposed method can achieve 3D shape, displacement and deformation measurement of dynamic scenes at a frame rate of 542 fps without any extra expense of hardware or calibration for the FPP system. The presented method is reliable and promising for further 3D displacement mapping and deformation analysis of dynamic scenes using FPP.