Abstract
The data acquisition system is a system which collects the analog signal from the sensor, converts it into digital signal, then sends it to the computer for processing, and outputs the processing results in the form of demand. Based on the research of USB technology, this paper describes a data acquisition system based on data fusion technology, including hardware design, firmware design, device driver design and host application design. In the part of hardware design, this paper first describes the performance and characteristics of data acquisition chip, FPGA and USB2.0 interface chip, and then gives the specific hardware design scheme. In the part of firmware design, this paper first introduces the firmware architecture of FX2, and then introduces the firmware design of GPIF interface mode in detail. In the driver development part, this paper first introduces the WDM driver development model, and then completes the USB device driver design of the data acquisition system. Finally, the device performance data acquisition system based on data fusion method is completed with driver.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
