Abstract
Blank design is an important task in sheet metal forming process optimization. The initial blank shape has direct effect on the part quality. This paper presents a deformation based blank design approach to determine the initial blank shape for a formed part. The blank design approach is integrated separately into ABAQUS, and DD3IMP, a research purpose in-house FEA code, to demonstrate its compatibility with any FEA code. The algorithm uses FE results to optimize the blank shape for a part. Deep drawing simulation of a rectangular cup geometry was carried out with an initial blank shape determined empirically. The blank shape was iteratively modified, based on the deformation history, until an optimal blank shape for the part is achieved. The optimal blank shapes predicted by the algorithm using both FEA softwares were similar. Marginal differences in the shape error indicate that the deformation history based push/pull technique can effectively determine an optimal blank shape for a part with any FEA software. For the shape error selected, both procedures estimate the optimal blank shape for the part within five iterations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Mechanics and Materials in Design
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
