Abstract
Based on the geometry of the cutter, the dynamic force model of face milling was established. Meanwhile, the fast and effective identification method of milling force model coefficients was provided, which combining the virtues of both orthogonal design theory and partial least-square regression (PLSR) method. Milling experiments have been conducted to verify the proposed face milling force model. Good agreements between the experimental and simulated results were presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
