Abstract

The use of cryosectioning facilitates the morphological analysis and immunocytochemistry of cells in tissues in atomic force microscopy (AFM). The cantilever can access all parts of a tissue sample in cryosections after the embedding medium (sucrose) has been replaced with phosphate-buffered saline (PBS), and this approach has enabled the production of a type of high-resolution image. The images resembled those obtained from freeze-etching replica electron microscopy (EM) rather than from thin-section EM. The AFM images showed disks stacked and enveloped by the cell membrane in rod photoreceptor outer segments (ROS) at EM resolution. In addition, ciliary necklaces on the surface of connecting cilium, three-dimensional architecture of synaptic ribbons, and the surface of the post-synaptic membrane facing the active site were revealed, which were not apparent using thin-section EM. AFM could depict the molecular binding of anti-opsin antibodies conjugated to a secondary fluorescent antibody bound to the disk membrane. The specific localization of the anti-opsin binding sites was verified through correlation with immunofluorescence signals in AFM combined with confocal fluorescence microscope. To prove reproducibility in other tissues besides retina, cryosectioning-AFM was also applied to elucidate molecular organization of sarcomere in a rabbit psoas muscle.

Highlights

  • Previous studies have used conventional plastic sections[6,7,8,9,10,11,12]

  • The structural information provided by atomic force microscopy (AFM) is different in principle from the information obtained by both electron microscopy (EM) and light microscopy (LM)

  • Images that are obtained using LM and EM are formed by the scattering, interference and absorption of electrons or photons, but AFM produces an image by touching the surface of the specimen with a scanning needle

Read more

Summary

Introduction

Previous studies have used conventional plastic sections[6,7,8,9,10,11,12]. Only the cell contours and some organelles were faintly detected because the cutting surface of the resin-embedded sample was flat without removing the resin. AFM forms images by touching and scanning the sample with a needle, but structures never appear unless the resin is removed. One study using plastic sections successfully embossed the inside structures by dissolving the surface of thin sections with alcohol[7]. This study focused on cryosections prepared using the Tokuyasu method[13,14,15] in which samples are fixed slightly with glutaraldehyde and embedded in sucrose. A capacity for immunocytochemistry in AFM would be possible when using this method

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call