Abstract

Problem statement: Wireline formation testing (also named Mini-DSTs) are gaining more and more popularity as a possible alternative to co nventional well testing especially where there are major environmental and economical constraints. The increased offshore exploration activity, which often implies highly risky and huge operational cos ts, makes the conventional well testing less attractive in favor of other technologies that can provide some of the key dynamic information about the well-reservoir system through relatively quick and less expensive operations. The design phase is recognized to be one of the most critical aspects i n order to guarantee an acceptable value of information in exploration scenarios where very lim ited data is available. The success of any mini- DST operation can be significantly compromised if t wo major issues are not addressed in the design phase: possibility to clearly identify the radial f low behavior and avoidance of noise in the pressure response due to the gauge resolution. Approach: The study consisted in the development of a new too l for mini-DST design to easily identify whether this technology can be successfully applied. The tool comprises dimensionless and dimensional charts, which are of general validity because they can be applied to any lithological environment and for any type of hydrocarbon. Results: Field applications proved the reliability of the charts: First of all the test durations were optimized to collect interp retable bottomhole pressures and to obtain valid reservoir characterizations. Besides, a cost saving effectiveness was achieved avoiding the acquisition of useless extra-data affected by noise due to gauge resolution. Conclusion/Recommendations: The use of the charts is strongly suggested at the early stage of decision making for new exploration/ appraisal operations; they are a user-friendly tool for assessing the feasibility of a mini-DST test. A dditionally, the charts are more versatile with res pect to available commercial software in managing uncertainties of the major input parameters.

Highlights

  • The wireline formation test technology consists in producing the reservoir fluid directly in the wellbore using a downhole pump so as to avoid hydrocarbons flow at the surface

  • The tool comprises dimensionless and dimensional charts, which are of general validity because they can be applied to any lithological environment and for any type of hydrocarbon

  • It is extremely important to evaluate whether the mini-DST can guarantee an acceptable value of information, minimizing the risk of collecting useless data with a waste of time and money and provide the possibility to obtain a reservoir dynamic characterization, around the wellbore

Read more

Summary

INTRODUCTION

The wireline formation test technology consists in producing the reservoir fluid directly in the wellbore using a downhole pump so as to avoid hydrocarbons flow at the surface. After this short production period, a pressure build-up occurs. Sci., 5 (6): 772-780, 2009 wellbore instability, there are two main causes that might compromise the success of a mini-DST: build-up duration too short to reach radial flow conditions and invalid test data due to insufficient draw-down and/or gauge resolution. The design charts presented in this study were conceived to provide a user-friendly tool to quickly establish the feasibility of a test and to properly estimate the draw-down and build-up durations. In the following the basic idea from which the charts were developed is first introduced, the equation needed to plot them are examined

MATERIALS AND METHODS
RESULTS AND DISCUSSION
CONCLUSION

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.