Abstract
Constant on-time control has been widely used due to its advantages of fast transient response and light load efficiency. However, the control scheme is intrinsically unstable if the output capacitor's equivalent series resistance (ESR) is not large enough, which needs ripple injection techniques to enhance loop stability. The traditional passive ripple compensation technique uses only passive component networks to realize this function, which exhibits some inherent shortcomings, including difficulties in high-speed current sensing amplifier design and large chip area consumption. This paper proposes an internal active ripple compensation strategy that senses the low-side power mosfet current and extracts relevant ac information for feedback-ripple enhancement. Output-voltage dc offset does not occur and subharmonic instability is significantly improved even with ceramic capacitors. The circuit architecture has been realized in a synchronous buck regulator with a 0.5 μm 40 V bipolar-CMOS-DMOS (BCD) process. The programmable switching frequency is up to 1 MHz and the maximum load current is 4 A. Simulation and experimental results are given to prove the proposed high performance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
