A cone-beam computed tomographic evaluation of alveolar bone dimensional changes and the periodontal limits of mandibular incisor advancement in skeletal Class II patients.

Abstract

To evaluate the presence of dehiscences and changes in alveolar bone height and width in the area of the mandibular central incisors pre- and post-orthodontic treatment. In 60 skeletal Class II patients, cone-beam computed tomographic (CBCT) images were obtained and the patients were divided into four groups based on the presence of dehiscences at pre- and post-orthodontic treatment. The alveolar bone height and width were measured on CBCT in cross section along the long axis of the teeth. Lateral cephalograms were analyzed. The changes in L1-NB and IMPA appeared to be correlated with vertical bone loss and dehiscence. Alveolar bone height appeared to follow a segmented relationship with these two variables, with changes below a threshold (L1-NB = 0.71 mm, IMPA = 3.02°) having relatively minimal or no effect on bone loss but with changes beyond the threshold correlated with extensive bone loss. Similarly, increases in L1-NB or IMPA correlated with decreases in alveolar bone width (L1-NB: -0.25 mm/mm, IMPA: -0.07 mm/°) and increased the probability of developing dehiscences, with an estimated 50% probability of vertical bone loss at a L1-NB change of 2.00 mm or, equivalently, an IMPA change of 8.02° was estimated. When treating skeletal Class II patients, the limits of incisor proclination/protraction are less than previously thought. To prevent undesired periodontal outcomes, careful three-dimensional diagnosis is advisable. Furthermore, when excessive protrusion and/or proclination is planned, additional treatment modalities, including orthognathic surgery, tooth extraction, and corticotomy with bone graft, should be considered.