Abstract
Precision is important if small polyethylene wear rates are to be detected early and in small sample sizes. Using an automatic, computerized algorithm relying on a synthetic X-ray generated from a computer-assisted design (CAD) model of the implant may significantly improve precision of linear wear measurements. We compared this method to provide improved in vivo precision compared to the widely used Hip Analysis Suite software (version 8.0.1.7). Two anterior-posterior pelvic X-rays were taken on the same day of 18 total hip implants, and wear was measured by three observers using the two methods. Expected real wear was zero and defined as a reference value. Two sources of variability were estimated: one due to the instrument, and one due to different operators. A Wilcoxon Signed Rank Test was used for statistical comparisons. The overall precision (instrument variability and multioperator variability) given a 95% precision limit was significantly higher (p < 0.001) using the proposed method (+/-0.15 mm) when compared to the Hip Analysis Suite (+/-0.84 mm). Due to the availability of the full CAD data of the implant and to further automation of the measuring process, the newly proposed method provided improved precision in measuring polyethylene wear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.