Abstract
This paper presents and discusses results from a computer simulation of a battery energy storage/converter system connected to a representative utility substation. Switching of load, voltage waveforms, voltage levels, fault conditions, and power flow reversal are investigated for both line- and forced-cornmutated converters in the application. The interactions among the battery, the converter and its controls, and the substation are discussed. The investigations have pointed out areas in which further consideration must be given to component selection for the battery/utility interface equipment, for example, dc reactor sizing, harmonic filtering, power factor control, thyristor firing control, and dc current interruption.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.