Abstract
In this study, the linear response of fission chamber (FC) neutron detectors in Isfahan miniature neutron source reactor (MNSR) is investigated through experiments and calculations at different powers of the reactor. The linearity of the response of the main neutron detector in the MNSR is important due to its safety functions in reactor power control. Additionally, determining the linear response region of this detector presents a linear neutron dosimetry field even outside of the reactor core, i.e. at the outlet of external beam tubes. Moreover, it is very difficult to remove and calibrate this neutron detector that has been installed in the reactor core for a long time. For this purpose, an alternative method for measuring the linearity of the response of a neutron detector is extended by investigating the kinetic behavior of reactor. The aim of this method is to calculate the delayed neutrons population in the reactor core and compare with the FC detector response. In this method, the numerical solution method is used to solve the point kinetic equation with 15 delayed neutron groups (6 delayed neutron groups and 9 photo-neutron groups) after inserting a large negative reactivity into the MNSR core by considering temperature and xenon reactivity feedbacks during a coupling procedure. To obtain the xenon reactivity feedback, xenon concentration is calculated by coupling the 135Xe and 135I production equations and the εpPFnlPTnl parameter is obtained by an experimental method. Furthermore, the value of fission cross section (Σf) is calculated using a validated model in the Dragon code. The large reactivities are inserted at two initial power of 150 W and 30 kW to investigate the response of the main FC neutron detector in a cold xenon-free condition and by considering temperature and xenon reactivity feedbacks, respectively. The results demonstrate that the response of the MNSR FC detector is linear in the neutron flux range between 5 × 107 to 1 × 1012 n.cm−2.s−1, which is equivalent to reactor power of 1.5 W to 30 kW. This innovative method can be applied to calibrate the neutron detectors in other research and power reactors.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.