A Comprehensive Investigation into the Effect of a Low Surface Energy Treatment on Gas Hydrate, Asphaltene, and Wax Formation, Deposition, and Adhesion

Abstract

SummaryThe formation/precipitation and deposition of pipeline solids, such as gas hydrates, asphaltenes, and waxes have long plagued production fields. Given the vast differences in chemistries of these solids, any current prevention or mitigation strategy, particularly for cases in which multiple issues are a concern, is likely to involve an extensive assortment of chemical additives that are both costly and add complexity to the system. Surface treatments (coatings), on the other hand, present a relatively viable option for management strategies. A chemically and physically robust surface treatment with the ability to address deposition issues for multiple pipeline solids could not only decrease the operating expenditures for a field through material cost savings and obviation of downstream separation, but could also simplify produced fluids by eliminating additional chemicals from the mixture.The purpose of this study was to explore the feasibility of a particular surface treatment as part of a solids management strategy. This work used an omniphobic surface treatment to probe its effects on gas hydrate, asphaltene, and wax deposition. Specifically, an interfacial tensiometer (IFT) collected contact angle measurements for wettability studies. High-pressure rocking cells studied gas hydrate nucleation and deposition. A bench-scale flow loop quantified the deposition of oil and asphaltenes after a set time period. Finally, a mechanical shear device measured the adhesion force of wax deposits on untreated/treated surfaces.Static contact angle results showed that the omniphobic surface treatment had reduced surface interaction with water droplets in air, altering from the complete wetting on corroded surfaces to slightly hydrophobic conditions of greater than 100°. In addition, rocking-cell tests indicated that these omniphobic surface treatments may prevent gas hydrate deposition for up to 72 hours. The gas hydrate rocking-cell tests also demonstrated possible increases in induction time and occasional elimination of hydrate nucleation with the surface treatment. Finally, the surface treatment application, which also decreased surface roughness, showed that crude oil and asphaltene particles deposition, as well as the shear required to remove solidified wax deposits, could be reduced by a large factor. Overall, promising results were recorded for all major flow-assurance solids in the presence of the surface treatment.