Abstract
Abstract Universal spindle of Finishing Stand in Hot Strip Mill (HSM) plays a vital role in providing product thickness as per customer requirement. In a rolling mill, upper and lower work rolls are connected with single motor by their respective universal spindle. The spindle allows upward and downward movement of work rolls by allowing its shaft to bend up to ~15o angle. This bending is only possible by universal cross positioned at its both ends. One of the cross bearing located at operator side got failed during operation. All the site evidences were carefully noted down and piled up to find out the root cause of the failure. Metallurgical analysis like microstructure, hardness, inclusion rating and chemical analysis were carried to find out material related issue if any. Quality of lubricants used at different pins of cross bearing was also checked by crackle test. Evidences and metallurgical analysis results suggested that the cross bearing failed due to deterioration of lubricant quality during service. Lubricant deteriorated due to water ingress into cross bearing through its polymeric seal which was not properly applied at the time of its assembly.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
