A composite-structured-light 3D measurement method based on fringe parameter calibration

Abstract

This paper proposes a novel method for reducing measurement error caused by spectrum overlapping in composite-structured-light 3D measurement systems. For a composite-structured-light 3D measurement system, spectrum overlapping causes parameters of each deformed phase-shifting fringe to change, and therefore leads to phase measurement errors. The proposed fringe parameter calibration method is based on the fact that variations in each deformed fringe's parameters are independent of height and reflectivity of the measured object. Three frames of composite grating are projected on the reference plane, and each carrier channel includes the information of three phase-shifting sinusoidal gratings used in Phase Measuring Profilometry (PMP). With the parameter calculation formulas of PMP, the parameters of fringes demodulated from the same carrier channel can be calculated, and therefore parameter relation coefficients between fringes demodulated from different carrier channels may be obtained. When an object is measured, these relation coefficients can be used to calibrate the parameters of the deformed phase-shifting fringes. A new 3D measurement mathematical model is established to reconstruct the shape of the object. Experimental data proved that the proposed method can effectively restrain the effect of spectrum overlapping and improve measurement accuracy by more than three times. ► Our experimental investigations indicated that spectrum overlapping occurred. ► Spectrum overlapping changes each demodulated phase-shifting fringe's parameters. ► A method of fringe parameter calibration is presented. ► A new 3D measurement mathematical model is established.