Abstract

Scanning force microscopy (SFM) studies of atmospheric corrosion of pure copper require a clean, homogeneous and smooth metal surface in order to image small changes. In this study various preparation methods for samples of copper sheets were tested: chemical etching, mechanical polishing as well as electrochemical polishing. In addition to copper sheet samples also specimen of sputtered copper obtained by physical vapour deposition on quartz substrates were chemically etched. In conclusion, mechanical polishing with monocrystalline diamond paste and electrochemical polishing of copper sheet yielded the most suitable surface condition for in situ investigations by means of SFM. Tapping mode atomic force microscopy (TM-AFM) was applied to gain information about the topography changes of the copper surface. Furthermore, the root mean square (rms) roughness of the sample surfaces was determined and delivered additional arguments for the applicability of the various surface treatments for in situ studies.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.