Abstract
Three different methods for finishing and polishing amalgam surfaces were studied by determining the roughness (Ra) of specimens at different stages of the procedures. Method I consisted of green stone, followed in sequence by finishing bur and pastes of pumice, powdered chalk, and SnO2. Method II was similar to method I but included brown and green Shofu polishers after the finishing bur. In method III medium and fine sandpaper and fine cuttle-paper discs were used before the pastes. A dramatic decrease in the Ra values was observed after the specimens had been ground with green stones, finishing burs, and sandpaper discs. Pumice resulted in a further reduction in Ra values. However, no significant differences in Ra values were found between the brown Shofu polisher, the fine cuttle-paper disc, and the different pastes. The lowest Ra value--that is, the highest smoothness--was obtained with green Shofu polisher.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
