Abstract
A high-Zn Al–27Zn-1.5Mg-1.2Cu-0.08Zr alloy was prepared by traditional casting and melt spinning. The as-casted alloy consists of well-developed α-Al dendrites with many coarse η-phase and low solute concentration, coarse network precipitates at grain boundaries and the α-Al/η-phase eutectic structures at triple junctions. Due to these featured structures, the as-cast alloy exhibits a low tensile strength of 101 MPa with room temperature and high temperature (300 °C) damping capacity of 0.0058 and 0.027 respectively. Comparatively, the as-spun alloy reveals gradient cross-sectional microstructures after solidification: an ultrafine grained region near the wheel surface, a transition region and an equiaxed-grained region near the ribbon free surface, with changes of precipitate morphologies from granular shape to network shape via vermicular. High-density nano-sized η′-phase/GP-zones within α-Al grains result in a higher tensile strength (121 MPa) of as-spun alloy with room temperature and high temperature (300 °C) damping capacity of 0.0049 and 0.048 respectively. Fracture analysis shows that the as-casted alloy fails in a mixed-mode fracture, comprised predominantly of transgranular fracture, quasi-cleavage fracture, cleavage fracture and dimple fracture, whereas the as-spun alloy failed in cleavage fracture and dimple fracture.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
