A Comparative Study of "Grafting to" and "Grafting from" Conjugation Methods for the Preparation of Antibody-Temperature-Responsive Polymer Conjugates.

Abstract

Early diagnosis of infectious diseases is still challenging particularly in a nonlaboratory environment or limited resources areas. Thus, sensitive, inexpensive, and easily handled diagnostic approaches are required. The lateral flow immunoassay (LFIA) is commonly used in the screening of infectious diseases despite its poor sensitivity, especially with low pathogenic loads (early stages of infection). This article introduces a novel polymeric material that might help in the enrichment and concentration of pathogens to overcome the LFIA misdiagnosis. To achieve this, we evaluated the efficiency of introducing poly(N-isopropylacrylamide) (PNIPAAm) into immunoglobulin G (IgG) as a model antibody using two different conjugation methods: grafting to (GT) and grafting from (GF). The IgG-PNIPAAm conjugates were characterized using SDS-PAGE, DLS, and temperature-responsive phase transition behavior. SDS-PAGE analysis revealed that the GF method was more efficient in introducing the polymer than the GT method, with calculated polymer introduction ratios of 61% and 34%, respectively. The GF method proved to be less susceptible to steric hindrance and more efficient in introducing high-molecular-weight polymers into proteins. These results are consistent with previous studies comparing the GT and GF methods in similar systems. This study represents an important step toward understanding how the choice of polymer incorporation method affects the properties of IgG-PNIPAAm conjugates. The synthesized polymer allowed binding and enrichment of mouse IgG that was used as a model antigen with a clear LFIA band. On the basis of our findings, this system might help in improving the sensitivity of simple diagnostics.