A comparative study of flame-wall interaction and flame-cooling air interaction

Abstract

This paper presents a three-dimensional (3D) direct numerical simulation (DNS) study of flame-wall interaction (FWI) and flame-cooling air interaction (FCAI). A preheated, methane/air mixture enters a channel with constant temperature walls, where the top wall is effusion cooled. An imposed vertical hot sheet near the inlet creates two flame branches interacting with the top and bottom walls. The flame is observed to be leaner in the region where it interacts with the effusion cooling jets. In this region, the flame is longer and features reduced CO mass fraction. The fluctuations in the heat release rate (HRR) and CO mass fraction are also relatively small near the top wall. Near the bottom wall, finger-like flame structures are formed due to the interaction of turbulent vortices with the flame surface. These flame structures initially move away from the wall as they propagate further downstream before eventually collapsing at the wall. This leads to the creation of regions of high wall heat flux and CO. While analysis of the CO thermochemical state shows a complex picture near the bottom wall, two-dimensional (2D) manifolds can be identified near the top wall. Therefore, a framework to estimate CO mass fraction due to FCAI based on 1D freely-propagating flame solutions is proposed showing a good agreement with the DNS results.