Abstract

This paper presents a comparative study of polymer pixel on sensors obtained by Laser Induced Forward Transfer (LIFT) assisted by a triazene polymer as Dynamic Release Layer (DRL). Polyisobutylene (PIB) was selected as model for chemoselective polymers which could be used as hydrogen-bond acidic polymer for vapor sensors. PIB films deposited on fused silica, respectively, on triazene polymer coated fused silica substrates were used as targets. Both targets were prepared by Matrix Assisted Pulsed Laser Evaporation (MAPLE). The parameters related to a regular, well-defined transfer were analyzed and compared for the substrates with and without the DRL. The morphological characterization of the transferred PIB was performed by Atomic Force Microscopy (AFM), Optical Microscopy, and Scanning Electron Microscopy (SEM). It was found that a minimal thickness of the dynamic release layer, i.e. 100 nm is required to protect the sensitive PIB polymer in a clean laser transfer process.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.