Abstract
Cemented carbide parts have been manufactured from WC-12Co granules by “Solvent on Granules 3D-Printing” and compared with reference parts produced by conventional press and sintering. SG-3DP consists in growing a green part layer-by-layer by selective solvent jetting on powder-polymer granule beds. Both 3D printed green parts and uniaxially pressed compacts have been consolidated by thermal debinding and liquid phase sintering. Further densification has been achieved by hot isostatic pressing.3D-printed parts subjected to hot isostatic pressing exhibit 99.9% of theoretical density, 1308 ± 10 HV30 hardness and 12.1 ± 0.3 MPa∙m½ indentation toughness, which are comparable to properties of a commercial fine grained WC-12Co. Percussion drilling tests with fully dense SG-3DP drill plates have also been carried out successfully on concrete.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Refractory Metals and Hard Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
