Abstract

Extrusion-based three-dimensional (3D) printing is an emerging technology which has a high application potential in food manufacturing processes. Screw and syringe-based printers are two kinds of extrusion-based 3D printing methods that have been widely studied and reported. The objective of present work was to compare these two different kinds of extrusion-based food 3D printing methods, in fluid flow characteristics and printing profile by computational simulation model and printing experiment. Analysis of simulated model suggested that the screw-based 3D food printer had a complex fluid characteristic, and some backflows were found at the gap between walls and the screw flights in the extrusion tube. Whereas, the syringe-based 3D food printer showed more simple fluid characteristics, which could be easy to adjust. Moreover, the experimental 3D printing suggested that the screw-based 3D food printer were not suitable for extruding the inks with high viscosity. Results in present work provides information for suitable printing method selection, a theoretical base and technical guide for further 3D printing studies and new printer designing.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.