Abstract

This paper presents a comparison of the behavior of the intrinsic diode of silicon (Si) and silicon carbide (SiC) MOSFETs. The study was done for 1200 V Si and SiC MOSFETs. The data sheet from manufacturers shows the characteristics of MOSFET' intrinsic diode when gate source voltage (V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">GS</sub> ) is 0 V. There are applications where the MOSFET' intrinsic diode is used while V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">GS</sub> is different than 0 V. One of these applications is induction heating, where depending on the load and the regulation system, the diode can conduct a significant part of the inverter current. In most applications which use the MOSFET' intrinsic diode, the turn ON of the intrinsic diode happens at V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">GS</sub> = 0 V. After a blanking time, the MOSFET' gate is activated waiting for the direction change of current in the circuit. Therefore, most of the current through the MOSFET' intrinsic diode occurs with a V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">GS</sub> different of 0 V. This paper shows the direct output characterization of Si and SiC MOSFET' intrinsic diode under different gate voltages. The gate resistor (R <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">G</sub> ) is an important parameter of the characterization. Depending on the input capacitance of the Si or SiC MOSFET, different R <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">G</sub> are needed. The turn-on and turn-off behaviors are obtained when RG is optimized for each Si and SiC MOSFET. This has result in the turn-off robustness of intrinsic diode with optimum R <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">G</sub> . This paper presents a surprising result for the reverse characteristic of Si and SiC MOSFETs for the same current at different V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">GS</sub> . The technology of Si MOSFET has different behavior depending on the manufacturer. The technology of SiC MOSFET presents a very similar behavior to low-voltage Si MOSFETs.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.