Abstract
In order to obtain better performance, 3D printed parts can be the subject of post-processing operations like sanding, gap filling, polishing, annealing, epoxy coating, and metal plating. This paper takes into consideration the most commonly used material filament for FFF technology PLA and studies the mechanical characteristics through tensile and 3-point bending tests. The obtained results reveal significantly higher values of the mechanical properties after applying a 3-hour heat treatment at 75°C, for the following combinations of parameters: layer thickness of 0.10, 0.15, and 0.20mm and infill percentage of 50%, 75%, and 100%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Engineering, Technology & Applied Science Research
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.