Abstract
The phase and amplitude gradient estimator (PAGE) method [Thomas, Christensen, and Gee, J. Acoust. Soc. Am. 137, 3366-3376 (2015)] has been developed as an alternative to the traditional p-p method for calculating energy-based acoustic measures such as active acoustic intensity. While this method shows many marked improvements over the traditional method, such as a wider valid frequency bandwidth for broadband sources, contaminating noise can lead to inaccurate results. Contaminating noise degrades performance for both the traditional and PAGE methods and causes probe microphone pairs to exhibit low coherence. When coherence is low, better estimates of the pressure magnitude and gradient can be obtained by using a coherence-based approach, which yields a more accurate intensity estimate. This coherence-based approach to the PAGE method, known as the CPAGE method, employs two main coherence-based adjustments. The pressure magnitude adjustment mitigates the negative impact of uncorrelated contaminating noise and improves intensity magnitude calculation. The phase gradient adjustment uses coherence as a weighting to calculate the phase gradient for the probe and improves primarily the calculation of intensity direction. Though requiring a greater computation time than the PAGE method, the CPAGE method is shown to improve intensity calculations, both in magnitude and direction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.