Abstract
A monolithic solution to the problem of sending and receiving data over power lines has been developed. The self-contained bipolar chip handles half-duplex serial data at up to 4K baud by FSK modulating a carrier frequency set at between 50 and 300 kHz. The transmitter section drives the line with a low distortion (0.1 percent) sine wave to minimize potential RFI. The 200 mW output originates from a transient-hardened on-chip transistor, and is in the form of a current that adapts to the widely varying power line impedance. The PLL receiver section has a sensitivity of 1 mV and contains a special impulse noise filter to reduce the effects of power line noise. Data of virtually any coding will pass through the system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.