Abstract
To date, many researchers have investigated the use of a shaving cutter for finishing a cylindrical gear with an involute tooth profile. They did not require a calculation method of the cutting-edge profile of the conventional shaving cutter, because it has a crossed helical gear profile. However, it is difficult to calculate the cutting-edge profile of a plunge-cut shaving cutter. In this report, a new calculation method of the cutting-edge profile of a shaving cutter for finishing the helical gear with an arbitrary tooth profile is proposed, which is not only applicable to the conventional cutter, but also to the plunge-cut shaving cutter. As a numerical example, the cutting-edge profile of the cutter which can produce the helical gear with the involute or the cycloid tooth profile is calculated, and a change in the surface of the plunge-cut cutter is shown by means of a contour map.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
