Abstract
A bandpass SD Modulator (SDM) ADC uses negative feedback of a bandpass-filtered error-signal and a high oversampling ratio to reduce the in-band errors of a low-resolution quantizer. As high-order (>4) bandpass SDMs exhibit signal-dependent stability, multibit quantizers are often used to lower the quantization noise of a 2nd or 4th order SDM. However, the accuracy required of the intermediate quantizer levels is high as mismatch affects the overall SDM performance. A 6th-order SDM has a single-bit quantizer for digitizing IF signals of 10.7 MHz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
