Abstract
A programmable-gain amplifier (PGA) circuit introduced in this paper has a dynamic gain range of 98 dB with 2 dB gain steps and is controlled by 6-bit gain control bits for a 3 V power supply. It has been fabricated in a 0.5 /spl mu/m 15 GHz f/sub T/ Si BiCMOS process and draws 13 mA. The active die area taken up by the circuit is 400 /spl mu/m /spl times/ 1170 /spl mu/m. A noise figure (NF) of 4.9 dB was measured at the maximum gain setting. In addition, an analysis of the bias current generation to provide dB-linear gain control is presented.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
