A 3.3-mW 25.2-to-29.4-GHz Current-Reuse VCO Using a Single-Turn Multi-Tap Inductor and Differential-Only Switched-Capacitor Arrays With a 187.6-dBc/Hz FOM

Abstract

A millimeter-wave current-reuse voltage-controlled oscillator (VCO) features a single-turn multi-tap inductor and two separate differential-only switched-capacitor arrays to improve the power efficiency and phase noise (PN). Specifically, a single-branch complementary VCO topology, in conjunction with a multi-resonant Resistor-Inductor-Capacitor-Mutual inductance (RLCM) tank, allows sharing the bias current and reshaping the impulse-sensitivity-function. The latter is based on an area- efficient RLCM tank to concurrently generate two high quality- factor differential-mode resonances at the fundamental and 2 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">nd</sup> - harmonic oscillation frequencies. Fabricated in 65-nm CMOS technology, our VCO at 27.7 GHz shows a PN of -109.91-dBc/Hz at 1-MHz offset (after on-chip divider-by-2), while consuming just 3.3 mW at a 1.1-V supply. It corresponds to a Figure-of-Merit (FOM) of 187.6 dBc/Hz. The frequency tuning range is 15.3% (25.2 to 29.4 GHz) and the core area is 0.116 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> .