Abstract
The two-dimensional (2-D) radiation-magnetohydrodynamic (R-MHD) code FOREV-2 was developed for modeling of disruptive hot plasma-wall interaction, for calculation of erosion by evaporation of the ITER-FEAT vertical divertor target, and for calculation of the impurity transport in the divertor. FOREV-2 uses a 2 1/2-D MHD model, a 2-D scheme for anisotropic radiation transport, and a solution of the magnetic field equations in the plasma shield for all three components of the magnetic field. Details of FOREV-2 with emphasis on the MHD equations, the equations for the magnetic field, the vaporization model, the angular dependent multigroup radiation transport, and the optical properties of plasmas, and validation of FOREV-2 against analytical results are discussed.Moreover, disruption simulation experiments, performed at the plasma gun facilities at TRINITI Troitsk were used for validation of FOREV-2 and for investigations of the MHD of typical plasma shields. From the results of the numerical analysis of the simulation experiments, it is concluded that turbulence in the experimental plasma shields is absent and that the stability of the cold and dense part of the plasma shields, which determines the target erosion, can be adequately modeled by FOREV-2 by use of the classical magnetic field diffusion coefficient. The experimentally observed downstream drift of plasma shields along the surface of the vertical targets is due to the lateral motion of a cold and dense plasma layer close to the target. The observed upstream shift of the erosion profiles of vertical targets is due to reradiation from the expanding plasma shield. Line radiation and an appropriate model for anisotropic radiation transport are necessary for a realistic calculation of the reradiation from carbon plasma shields. Moreover, inclusion of the line radiation allows one to get a realistic radiation cooling after switching off the heating. Target erosion in the simulation experiments is caused by radiation. The agreement between calculated and measured erosion for graphite and quartz demonstrates the adequacy of the calculated 2-D radiative target heat loads.The 2-D numerical analysis of the disruption simulation experiments allows one to conclude that such experiments adequately simulate the tokamak plasma shield properties and its dynamics. The extensive validation exercise of FOREV-2 against disruption simulation experiments gives confidence that the numerical analysis of erosion for the ITER-FEAT vertical targets during the thermal quench phase of a disruption and the impurity production during ELMs and its transport toward the x-point to be performed with FOREV-2 is based on sound principles and covers all important aspects of plasma shield behavior and plasma shield stability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.