836 Custom Fabricated Open Anterior Ankle Foot Orthosis to Promote Early Mobility with Lower Extremity Grafts

Abstract

Abstract Introduction Distal lower extremity STSG’s present a challenge with the balance of early mobility and immobilization of the ankle. Traditional commercially available ambulation boots or pre-fabricated orthotics may impose circumferential compression endangering graft integrity. Custom fabricated posterior AFO’s comprised of thermoplastic, scotch cast or fiberglass materials are not recommended for weight-bearing of the lower extremity during mobility/ambulation. What may also hinder promotion of early mobility is having a multitude of injuries or advanced age with decreased ability to adhere to a LE NWB status. An anterior approach to immobilization of the ankle was thought of to free the plantar surface of the foot for weight-bearing. The open concept of the orthosis itself minimizes direct contact with the involved LE graft. This promotes graft integrity during mobility with ankle immobilization. Methods Materials: Thermoplastic material, scissors, strapping, dense adhesive foam, adhesive Velcro and a heat gun. Fabrication: Measure the point of distance between where the desired proximal end of the orthosis would be to the patient’s metatarsal heads on the dorsal aspect of the foot; double it to calculate the amount of material needed. The width of the material should be approx. 3 to 4 inches. Warm material and tri-fold it together reducing width to approx. 1 ½ to 2 inches to increase stability. Shape the folded material into a continuous oval and place on the patient’s distal LE. As the material cools, shape the oval away from the medial/ lateral aspects of the distal LE restricting the points of contact to the anterior most proximal and distal aspect of the desired splint parameters. Remove once cooled and add dense adhesive foam to the 2 points of contact that will rest against the patient. This will allow for a slight area of “give” against the patient during weight-bearing of the LE/foot. Velcro and straps are added to the proximal/distal ends of the oval; heating the adhesive side will imbed the Velcro allowing increased durability with repeated donning/doffing. Results The open construction of this orthosis allows different degrees of weight-bearing eliminating contact with the distal LE STSG. The forefoot and heel are available to weight bear safely within the confines of the open anterior ankle foot orthosis. Conclusions Patients have been trialed with/without an AD with success in the achievement of ankle immobilization with mobility. Weight-bearing instructions that accompany this splint wear is foot placement rather than a normal heel strike cadence to avoid undue pressure at the proximal aspect of the splint on the lower extremity. Applicability of Research to Practice This splint has been successfully utilized for immobilization without compromise to STSG integrity due to the anterior open support it offers the ankle. Perhaps this concept could be applied to other joints to avoid direct contact of the splint with STSG during the initial stages of healing.